To connect N4200 series NAS to your network, follow the steps below:
1. Connect an Ethernet cable from your network to the WAN/LAN1 port on the
back panel of the N4200.
2. Connect the provided power cord into the universal power socket on the back
panel. Plug the other end of the cord into a surge protected socket.
3. Press the power button on the Front Panel to boot up the N4200.
To connect the N5200XXX/N5500 to your network, follow the steps below:
1. Connect an Ethernet cable from your network to the WAN/LAN1 port on the
back panel of the N5200XXX/N5500.
2. Connect the provided power cord into the universal power socket on the back
panel. Plug the other end of the cord into a surge protected socket. Press the
power supply switch to turn on the power supply.
To Next Page
Loading...
