CO
2
Incubator BB 150 Operating Instructions
65
13. Disposal
CAUTION – Contamination hazard!
The device can be used for preparing and pro-
cessing infectious substances so that the
device or device components may become
contaminated.
Before device components are discarded, they
must be decontaminated!
• The device components must be cleaned
thoroughly; after the cleaning, they must be
disinfected or sterilized, as required by the
application.
• Discarded devices or device components
must be provided with an appropriate cer-
tificate showing the decontamination mea-
sures performed.
All device components can be discarded properly after they have been decon-
taminated properly.
NOTE – Recycling service
Thermo Fisher Scientific Products offer, for a
small fee, an environmentally compatible re-
cycling service for discarded devices.
Component Material
Thermal insulation components Polystyrene foam EPS/PPS-Compound
Printed circuit boards
Enclosed electrical components coated with different
plastics, equipped on epoxy resin-bound boards.
Plastic components, general Note material labelling
Exterior housing Galvanized steel sheet, painted
Device rear panel Galvanized steel sheet
Outer door Galvanized steel sheet, painted
Door inner panel Galvanized steel sheet, painted
Operating panel and indicator foil Polyethylene
Magnetic door seal Magnetic core sheathed with EMPP
Heating Silicone-sheathed resistance-type wires
Interior containers, installed components
and shelves
Stainless steel 1.4301 or copper
Plug for pipe channel Silicone
Pressure compensation opening insert POM with brass sinter filter
Glas screen Soda-silicate glass
Glass door seal, measurement opening Tempered silicone
Sensor block Stainless steel 1.4301
Blower wheel Stainless steel 1.4305 or copper
Measuring cell baseplate seal Tempered silicone
Cables Plastic-sheathed copper flexible
Packaging Corrugated board, polyethylene film, and styrofoam
To Next Page
Loading...
Need help?
General
