Thermo Scientific HyPerforma G3Pro Universal Bioreactor Controller User’s Guide | 3
Warnings, safety, and warranty information
WARNING: Hot surface—do not touch.
The heating jacket is designed to heat the inner vessel wall. Normal
operating conditions generate heat and could create hot surfaces.
• Hot surface inside
• Contact with surfaces may cause burns
• Do not touch while in operation
WARNING: Pinch hazard.
The utility tower on the controller can be manually raised and lowered.
Caution should be used to avoid pinching an operator or causing
damage to the equipment.
WARNING: The Thermo Scientific HyPerforma G3Pro Universal
Bioreactor Controller may not be installed in a potentially
explosive atmosphere as set forth in the applicable EU ATEX
Directive. It is the responsibility of the end user to review and
understand the potential dangers listed in the ATEX 2014/34/EU
guidelines.
Controller cabinets
The controller does not contain user-serviceable internal components.
Any service must be performed by Thermo Fisher Scientific service
personnel, only.
Never open the controller cabinet, unless specifically instructed to do
so by a Thermo Fisher Scientific service team member.
All auxiliary equipment should be connected to the controller before the
controller is connected to the main power supply. If a piece of auxiliary
equipment is to be added or replaced, first turn o the power to the
controller and disconnect it from the main power.
Always disconnect the power before moving a control cabinet or other
piece of equipment.
Protective earth grounding
Protective earth grounding must be verified prior to plugging a piece of
auxiliary equipment into any electrical outlet. Ensure the connection is
properly earth grounded.
To Next Page
Loading...