Thermo Scientific HyPerforma G3Pro Universal Bioreactor Controller User’s Guide | 25
2.3.1 Installing pump tubing
1. To install pump tubing into the 100 or 300-series pumps, open the
pump head by lifting up on the upper curved section of the cover.
2. Lay the tubing into the pump over the driver (Fi g u r e 2.11).
3. Close the pump by bringing the top of the pump head down and
pressing firmly so it snaps closed.
Figure 2.8. 114 pump head. Figure 2.9. 313-series pump head.
Figure 2.10. 520 pump head.
Chapter 2 | Gas and liquid handling
To Next Page
Loading...