Model: SPD121P
Bleeder Valve: Integrated Automatic Bleeder Valve
Temperature Range: 35 °C-80 °C
Maximum Tube Size: 18 x 150 mm
Maximum Tube Capacity: 6
Maximum Carrier Capacity: 2 (96-deepwell plates) see chart on page 6
Dimensions: (W x D x H) in.: 14 x 18 x 13
cm: 36 x 45 x 33
Weight: lbs. (kg) 31 (14)
Power requirements: 115 VAC/60Hz, 5.0 A
(Part number SPD121P-115)
or
230 VAC/50Hz, 3.0 A
(Part number SPD121P-230)
All Thermo products mentioned in this manual (except glassware) are warranted against
defects in material and workmanship for one year after the date of delivery to the origi-
nal purchaser. Thermo’s warranty is limited to defective materials and workmanship,
and does not cover incidental or consequential damages. Warranty work is subject to
our inspection of the unit. No instruments, equipment, or accessories will be accepted
without a Return Material Authorization (RMA) number issued by Thermo. Costs of
shipping the unit are not covered under warranty. The warranty obliges you to follow
the precautions in this manual. It is the responsibility of the user to dispose of ALL
materials in a manner in accordance with all federal, state and local regulations. ALL
RETURNED UNITS MUST BE DECONTAMINATED AND FREE OF RADIOACTIVITY AND
SHOULD BE ACCOMPANIED WITH A DECONTAMINATION FORM. PLEASE CALL THER-
MO TO HAVE THIS FORM FAXED TO YOU! Under no circumstances shall Thermo be
liable for damages due to the improper handling or use of its products. Thermo
assumes no liability, express or implied, for your use of this equipment.
10
6.0 MAINTENANCE/SERVICE
1. Maintenance: The SpeedVac
®
SPD121P requires no scheduled maintenance.
2. Cleaning: The SpeedVac
®
SPD121P should be cleaned if solvents spill on or
inside the unit. Always clean up any spills immediately using absorbent
towels.
Always wear gloves when cleaning and dispose of paper towel in
appropriate designated refuse containers.
3. Replace chamber seal if cracked (Part number is 197-6020-00).
4. Outside of unit can be cleaned with dilute solution of soap and water.
5. For any other maintenance or service issues or service problems, please
contact Thermo.
7.0 SPECIFICATIONS/WARRANTY
To Next Page
Loading...
Need help?
General
