Thinkware VHL3Z-19G490-C - Final Connections and Verification; Secure Excess Cable; Connect IGN-3 F to Molex Connector; Verify LED Status and Operation

!
7 Wind!and!secure!any!excess!cable!(Fig!B)!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !
!
8 Place!the!vehicle!ignition!in!the!off!position,!connect!the!IGN-3F!to!the!10-pin!Molex!
connector!located!on!the!HWK-TW01-HAR!(Fig!C).!
!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !
9 Once!the!ignition!of!the!vehicle!is!off!and!the!IGN-3F!is!plugged!in,!the!LED!should!emit!a!
constant!flashing!light.!The!LED!will!go!from!the!blinking!state!to!a!continuous!ON!light!
once!the!vehicle!is!started.!When!the!light!is!ON!continuously,!an!ignition!phantom!
signal!will!be!sent!to!the!dashboard!to!turn!on,!and!it!will!stay!on!during!a!start!/!stop!
sequence,!the!LED!and!the!dashboard!will!turn!off!after!2!minutes,!30!seconds!from!the!
vehicle's!shutdown.!
!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !