THK KRF - Other Precautions

7-3
KRF
7. Installation and Operation
7.
Installation and Operation
7. Installation and Operation
7-3
Other precautions

If you use proximity sensors close to each other, they may interfere with each other. To
avoid such mutual interference, consider taking an appropriate measure such as keeping
a sufficient distance between the sensors and using sensors of different frequencies.
For details, see the catalog issued by the sensor manufacturer.

If a stainless steel sensor dog is used when a proximity sensor is used, note that the
detection distance is shorter than that of an iron dog.
For details, see the catalog issued by the sensor manufacturer.
* Sensor
·
GX-F12A, GX-F12B: Panasonic Industrial Devices SUNX Co., Ltd.

For selection and handling of a motor, see the respective catalog and instruction manual
issued by the motor manufacturer.
For data required to select a motor, see the appendix for your reference.

For selection, handling and mounting of a coupling, see the respective catalog issued by
the coupling manufacturer.
Check necessary data such as permissible torque, eccentricity, deection angle and tightening
torque of the assembly bolt.
* The maximum outer diameter of usable couplings
KRF3:
φ
17
KRF4:
φ
20
KRF5:
φ
20
KRF6:
φ
22