5
Setup and switch on
Unpack and check carefully there is no transportation damage before using the unit.
Keep the equipment packaging. To fully protect the device against vibration, dust
and moisture during transportation or storage use the original packaging or your
own packaging material suitable for transport or storage, respectively.
Establish all connections as long as the unit is switched off. Use the shortest possible
high-quality cables for all connections.
The scope of delivery comprises:
n Digital piano
n Sustain pedal
n Power supply unit
n User manual.
Make sure that everything was delivered properly and set the digital piano horizon‐
tally on a table or a suitable stand near an mains power wall outlet. Optionally, you
can mount the digital piano on the wooden stand with double pedal (article number
265835).
Then, carry out the following steps:
n Make sure that the cable from the power supply to the DC 12 V input jack on the
rear panel of the digital piano is long enough.
n Insert the score stand into the two holes on the operating panel.
n Connect the cable of the power supply output to the DC 12 V jack on the rear
panel of the digital piano.
n Insert the plug of the adapter into the wall outlet.
n Insert the plug of the pedal into the "SUSTAIN" jack on the rear panel of the dig‐
ital piano.
Make sure that the device is switched off when plugging and unplugging
the power plug.
Set the volume to minimum before turning on the device.
Setup and switch on
digital piano
10
To Next Page
Loading...
Need help?
General
