7
Operating elements
Press the [POWER] button in the upper left corner of the operating panel. The button
remains pressed when the unit is switched on. It is released to its original position
when the unit is switched off.
Use the [FUNCTION] button to select the operating mode. This lets you change the
parameters of many features, such as Touch Response, Split point, Layer, MIDI con‐
trol, etc.
Move the slider to the left to reduce the volume. Move it to the right to increase the
volume.
The LED display shows the status of the piano, or a value, mode, or the respective
function or voice for the current operating mode.
Use the rotary control [DATA CONTROL], to change the following parameter values:
n Voice
n Function
n Volume (0 – 127)
n Metronome tempo (20 – 280)
n Effect depth of reverb/chorus (0 – 127)
n Time signature
n Transpose value (–12 – +12)
n Octave shift (–3 – +3)
n Tuning (–64 – +63)
n Recording track
n MIDI channel/program number
n Bank MSB/LSB values (0 – 127).
If you don't use the [DATA CONTROL] knob for 10 seconds, it will return to its
standard function (metronome tempo setting).
Power ON/OFF (on/off switch)
FUNCTION button
MASTER VOLUME
LED display
Rotary control DATA CONTROL
Operating elements
digital piano
12
To Next Page
Loading...
Need help?
General
