How to connect the aerial, scart and co-axial cables
Caution : Always disconnect the receiver from the mains supply before you connect it
to any other equipment.
Unplug the aerial lead from your VCR (or TV) and connect it to the »RF IN« socket on the
rear of the receiver.
If connecting to a VCR, connect the aerial fly-lead that came with your VCR between
»
LLOOOOPP TTHHRROOUUGGHH OOUUTT
« on the receiver and aerial IN on the VCR.
Connect the scart lead from the »
TTVV SSCCAARRTT
« socket on the receiver to the AV1/EXT1/AUX1
scart IN on your TV.
Plug the power connector into the »
MMAAIINNSS IINNPPUUTT
« socket on the receiver.
If you wish to connect the audio outputs to your Hi-Fi or AV amplifier, you will need to
purchace the necessary phono cables ad connect them as shown above.
Note: If you wish to continue watching analogue TV on your television, you must
purchase an aerial fly-lead and connect it between the aerial IN on the TV and the
aerial OUT on the VCR (or the »
LLOOOOPP TTHHRROOUUGGHH OOUUTT
« on the receiver)
It is strongly recommended that the product be connected via scart leads to your TV
and VCR.
TV
Aerial
TV
VCR
RECEIVER
AV AMPLIFIER
AUX IN
LR
RF IN
RF LOOP
THROUGH
TV
MAINS
INPUT
VCR
L
R
v
w
x
u
Aerial Leads
Scart Leads
Note : For best results
connect the STB to the TV
using the scart lead supplied.
AV1
EXT1
AUX1
OUT
IN
IN
OUT
Not supplied - purchase separately if required
Not supplied
AUX
VIDEO
EXT
Phono Leads
(not supplied)
To Next Page
Loading...
