From time to time new services are launched which may require your receiver to be upgraded
with new software before you can use them. Sometimes new features may be introduced to
enhance your receiver.
Notification
This menu is automatically displayed when a new “Over-Air-
Download” is detected after switch on. You now have three
options.
● To start the download immediately, press [OK].
● Select DOWNLOAD LATER to set a timer event to receive
the new software during the night.
● Refuse the download at this time by pressing [QUIT].
(However, the download may be re-detected and
indicated the next time you switch on.) It is highly
recommended that you keep your receiver up to date.
Check for download
You can manually check to see if new software is available for download. If there is one
available, you will see the download menu as above.
To check:-
1. Press [MENU], select SETUP and press [OK].
2. Select CHECK FOR DOWNLOAD and press [OK].
3. If no download is available, press [QUIT] to exit.
4. Press [OK] to start. Alternatively, schedule the download for later.
The download can take up to 30 minutes or be slow to start, so please be patient. After the
download, details about the new software will be displayed for you. There may also be a
telephone number to call in case of any difficulty.
If the download fails, try again later.
During part of the download, DO NOT switch off the receiver, this warning is displayed on
screen.
12
UUppggrraaddiinngg yyoouurr RReecceeiivveerr
Use
To Next Page
Loading...
