Trouble Shooting
Not every picture or sound problem is caused by a defect in your Digital Terrestrial Receiver.
Leads having been accidentally pulled out or worn out batteries in the remote control can also
cause impairment. If your unit does something unexpected while you are using it, please unplug
it, wait a few seconds then plug it in again. If this fails to solve the problem or the following
measures do not bring about satisfactory results, please consult an authorised dealer.
Technical Information
This product fulfils the European directives 89/336/EEC, 73/23/EEC and 93/68/EEC. This device
conforms to the safety regulation DIN EN 60065 (VDE 0860) and therefore the international
safety regulation IEC 60065.
You may not open the Digital Terrestrial Receiver. The manufacturer accepts no liability for
damage resulting from improper handling
MMaaiinnss vvoollttaaggee:: PPoowweerr ccoonnssuummppttiioonn::
230V~, 50/60Hz Operating approx. 10W. Low power standby <1W
AAmmbbiieenntt tteemmppeerraattuurree:: AAuuddiioo FFoorrmmaatt::
+10°C to 35°C Analogue : Stereo Sound
DDiimmeennssiioonnss aanndd wweeiigghhtt
Dimensions : W x H x D - 252 x 43 x 153mm Weight : Approx. 0.7Kg
VViiddeeoo:
: AAuuddiioo::
Signal to noise : 73dB Signal-to-noise: 95dB
Video jitter : 1ns Interchannel isolation : 90dB
THD : 0.03%
TTrroouubbllee sshhoooottiinngg aanndd
tteecchhnniiccaall iinnffoorrmmaattiioonn
Use
FFAAUULLTT CCAAUUSSEE//RREEMMEEDDYY
Receiver does not Press STB button on handset.
respond to the Unit is in low power standby. Press Standby button on unit.
remote control Point the remote control directly at the receiver.
Remove all obstacles which may impair the path of the
remote control signal.
Check or replace the remote control batteries.
No Picture Check all connections at the rear of the unit
Disrupted Picture Check RF IN connection. Ensure cables to TV are inserted correctly
Select AV channel on TV set
Replace aerial outlet plate with shielded type
No Sound Check all connections at rear of unit
No Power Check mains plug is inserted correctly and receiver is switched on
14
To Next Page
Loading...
