6
Start up
Once the mains has been connected to the receiver, it will
take up to 15 seconds to start up. If this is the first time
installation, a menu will automatically appear.
Press [OK] when prompted.
If this is not the first time, follow the steps below :-
Auto tune
Once the receiver has been connected to the aerial and
television, the receiver can now be tuned in.
1. Press B on the handset to turn the receiver on.
2. Press [MENU].
3. Select SETUP with
//
and press [OK].
4. Select AUTO TUNE with
//
and press [OK].
5. Press [OK] to select REPLACE EXISTING SERVICES.
Now wait while the receiver searches for all the available
services, this may take a few minutes.
The receiver will place the services in numerical order.
6. Press [OK] or [QUIT] to exit the menu. Alternatively
see later in the guide how to sort your Service List.
As new services become available, upgrade the SERVICE
LIST by selecting the ADD NEW SERVICES option or, when
major changes occur, use REPLACE EXISTING SERVICES
option.
Manual tune
This allows an advanced user to manually tune services.
1. Select MANUAL TUNE from the SETUP menu and
press [OK].
2. Now enter the channel number to be tuned.
This menu also shows the aerial signal strength. The Level
bar shows GREEN for good, YELLOW for poor, or RED for
bad signals. The higher the Quality number, the better the
signal is.
By changing AUTO MODE to NO, it is possible to change
other reception parameters.
TTuunniinngg tthhee rreecceeiivveerr
Set-up
To Next Page
Loading...
