What to do if there is no picture or sound on my THOMSON Receiver?
If you're not getting any picture or sound, there are several things to check: * Ensure your TV is on the correct input. * Verify that the TV is powered on and the cables between the receiver and TV are firmly plugged in. Check the mains lead. * Make sure audio muting is off by pressing the ! button.
Why is my THOMSON Receiver remote control not working?
If your remote isn't working, try these steps: * Ensure the receiver is plugged in and turned on. * Aim the remote directly at the IR sensor on the receiver. * Check for any obstructions blocking the IR sensor. * Replace the batteries in the remote control.
How to fix no picture on my THOMSON Receiver?
If you're not getting a picture on your THOMSON Receiver, it might be due to a few reasons: * The receiver may not be receiving a signal. Check the antenna cable for damage, try replacing it, or ensure it's tightly connected to the receiver. * Incorrect tuner parameters can also cause this issue. Access the Installation menu and set the tuner parameters correctly. * The dish might be misaligned. Check the signal strength and adjust the dish accordingly.
What to do if my THOMSON Receiver switches to standby automatically?
If your receiver is automatically going into standby mode, it's likely because the Auto Standby function is activated. You can adjust the power down time or disable this feature altogether in the System Auto Standby menu.
What does 'scrambled channel message' mean on my THOMSON Receiver?
If you're seeing a 'scrambled channel message,' it simply means that the channel you're trying to watch is scrambled. Select an alternative channel.
Why is my THOMSON Receiver standby indicator not lighting up?
If the standby indicator isn't lighting up, it could be due to a simple issue. Check if the mains lead is properly plugged in and ensure the multipoint connector is switched on.
To Next Page
General
