P14
MAIN MENU
Rename a TV or radio programme
1. Select the programme you want to rename and press 9. A key table appears.
2. In the key table select a character by using the navigation buttons. Press OK to enter the
character. When you have entered the new name, navigate to the “OK” button on screen
and press OK on the remote control to confirm the new name.
3. To store the changes and exit the menu, press .
7.1.2 EPG (Electronic Programme Guide)
Please refer to section 6.8 above.
7.1.3 Sort
Here you can sort your channels in the following orders:
Default Sort the channels in the original order
By Encrypt Sort the channels from free to scrambled
By Frequency Sort the channels in frequency order (Low-High)
By Service Name Sort the channels in alphabetical order (A-Z)
Recall List
Enable or disable the Recall list function, which supports multi-recall-channel switching. If the status
is set ON then a list of previously selected channels will be displayed for new selection by pressing
the 9 button. If the status is set OFF then the receiver just will switch to the previously selected
channel by pressing the 9 button.
7.2 Picture
Press MENU, then select Picture. The menu provides options to adjust the video settings. Press p/q
to select an option and tu to adjust the setting. Press to exit the menu.
Aspect Ratio
You can set the display format to available settings like 16:9 Widescreen, 16:9 Pillarbox, 4:3 Letterbox,
4:3 Pan&Scan.
16:9 Widescreen For 16:9 TV screens. All programmes will fill the full screen. Content formatted
in 4:3 will be stretched.
16:9 Pillarbox For 16:9 TV screens. The unit will display all content in its original aspect ratio.
Programmes formatted in 4:3 will be presented with black bars on the left
and right.
4:3 Letterbox For 4:3 TV screens. The unit will display all content in its original aspect ratio.
Programmes formatted in 16:9 will be presented with black bars on the top
and bottom.
4:3 Pan&Scan For 4:3 TV screens.16:9 content will have the extreme left and right portions
cut off and presented full screen.
TIP You can change the video output format directly from viewing mode by
pressing the YELLOW button on the remote control.
To Next Page
