THOMSON Electrak LL - Ordering Key

Thomson
Thomson Electrak
®
LL Actuator - Installation Manual - 2020-1116
7.2 Ordering key
Ordering Key
Position 1 2 3 4 5 6 7 8 9
Example
LL24 B040- 0300 LEX 1 M M
S D
1. Actuator type and supply voltage
LL24 = Electrak LL, 24 Vdc
2. Screw type, dynamic load capacity
B040- = ball screw, 4.0 kN (899 lbs)
B060- = ball screw, 6.0 kN (1388 lbs)
3. Ordering stroke length
0100 = 100 mm
0150 = 150 mm
0200 = 200 mm
0250 = 250 mm
0300 = 300 mm
0350 = 350 mm
0400 = 400 mm
0450 = 450 mm
0500 = 500 mm
4. Electrak
®
Modular Control System options
LEX = Electronic Monitoring Package + low-level signal motor switching +
external end-o󰀨-stroke limit switch inputs
5. Cable option
1 = 0.3 m long cable
6. Rear adapter option
M = cross hole for 12 mm pin
E = cross hole for ½ inch pin
N = forked cross hole for 12 mm pin
F = forked cross hole for ½ inch pin
S = stainless cross hole for 12 mm pin
T = stainless forked cross hole for 12 mm pin
7. Front adapter option
M = cross hole for 12 mm pin
E = cross hole for ½ inch pin
N = forked cross hole for 12 mm pin
F = forked cross hole for ½ inch pin
P = metric female thread M12 × 1.75
G = inch female thread 1/2-20 UNF-2B
S = stainless cross hole for 12 mm pin
Q = stainless metric male thread M16 × 2
R = stainless metric female thread M16 × 2
T = stainless forked cross hole for 12 mm pin
8. Adapter orientation
S = standard
M = 90 ° turned
9. Connector option
D = ying leads