7. MAIN MENU
P19
Resolution Only selectable for HDMI
HDCP ON or OFF, please see the note above.
After all settings are adjusted following to your preference, choose Save with pq and press OK. The receiver
returns to the menu.
7.1.3.3 Select Audio Language
In this submenu you can set up to four preferred audio languages:
First Language Either use OK for a list with all available languages or use tu to select one.
Second Language Either use OK for a list with all available languages or use tu to select one.
Third Language Either use OK for a list with all available languages or use tu to select one.
Fourth Language Either use OK for a list with all available languages or use tu to select one.
The receiver will automatically switch to the preferred audio language whenever available. If the first language
is not available it will switch to the second language. Should both the first and the second language be
unavailable it switches to the third language and so on.
After all settings are adjusted following to your preference, choose Save with pq and press OK. The receiver
returns to the menu.
7.1.3.4 Select Subtitle Language
In this submenu you can set up if you want to display DVB subtitles and select your language accordingly:
Subtitle Display Use tu to select ON or OFF depending on DVB subtitle display being preferred or not.
Subtitle Language Either use OK for a list with all available languages or tu to select a language.
When available, DVB subtitles will be displayed in the selected language.
After all settings are adjusted following to your preference, choose Save with pq and press OK. The receiver
returns to the menu.
NOTE: If you have switched the Subtitle Setting to ON, then subtitles will be displayed automatically if
available for this channel/movie. When the setting is OFF the subtitles can be opened temporarily.
Further information about subtitles can be found on the respective videotext pages or websites of
the broadcast organisation.
7.1.4 Parental Lock
This menu enables you to define and edit your PIN code, set Installation or Parental Lock. Choose a setting with
pq and press OK to list the possibilities or use tu to change the value of the highlighted setting.
Please read the displayed instructions for each screen carefully. They will help you adjusting the settings correct
and easy.
Current PIN Code Use the 0~9 buttons to access this menu options below. Enter the (DEFAULT PIN:
0000) if you have not changed it.
Parental Lock Use tu to select ON or OFF. Parental Lock allows you to prevent children from
watching adult channels if these channels support EPG or submit EPG based parental
rate for your country. In below adjust the Parental Rate accordingly.
Installation Lock Use tu to select ON or OFF. Installation Lock allows you to lock the access to your
Installation settings and channel edit menus.
Parental Rate Use tu to change these settings. Following rates are available: Unblocked, 6+, 10+,
12+,16+ and 18+ or All Blocked. Depending on the adjusted setting you will have to
enter your PIN code when switching through channels which support EPG or submit
EPG based parental rate.
New PIN Code Enter the PIN code of choice with the 0~9 buttons.
Confirm PIN Code Use the 0~9 buttons to confirm your new PIN code.
When all settings have been made, press
to leave the Parental Lock menu. When returning to viewing mode
the receiver will inform with a message that it saves your settings.
To Next Page
Loading...
