129
6. Pump until solution is drawn out of the container, or tank is at the desired level.
7. Turn the pump Switch OFF.
8. Disconnect the garden hose from the city water ll inlet on the utility center.
1. Make sure the fresh water tank has an adequate supply of water.
2. Set the color coded valves to the DRY CAMPING setting:
(A) White handle pointing right
(B) Blue handle pointing down
(C) Black handle pointing down
(D) Red handle pointing up
(E) Green handle pointing up
3. Turn the pump switch ON.
4. Water should be available to all xtures.
5. Turn pump OFF when water is not being used.
1. Connect the fresh water hose to the city water inlet.
2. Set the color coded valves to the CITY WATER setting:
(A) White handle pointing right
(B) Blue handle pointing down
(C) Black handle pointing right
(D) Red handle pointing up
(E) Green handle pointing up
3. Connect other end of the hose to the pressurized fresh water
source.
4. Turn ON the pressurized water source.
5. Water should now be available to all xtures.
Turn o water at the pressurized source rst, disconnect hose from the water
source, (to release pressure o the system) then disconnect the hose at the city water con-
nection on utility center last.
To ll the fresh water tank without a pressurized water source,
refer to SANITIZE (Siphon Fill) section, and use a container holding fresh
potable water and a hose. Water will be drawn into the tank by the pump.
There is no gravity ll inlet on the recreation vehicle.
For winterizing instructions, refer to the Winterizing
the Plumbing System section.
To Next Page
Loading...
