97
○ When a motor is in operation, motor control is disabled on any other device run-
ning the RVMaster app.
Shows the thermostat to control heating and cooling in the RV, and fan speed
Turn lights on and o along with ability to dim certain lighting with sliders.
Shows generator on and o, AGS (auto generator start), battery levels, and fuel levels
Shows Kitchen and bath fans and automatic vents (if equipped). Turn fans on and o and
open and close automatic vents.
(gear icon at top right corner)
• Check the Bluetooth connection between RVMasterController (touchscreen) and
the RVMasterNode.
• Set your preferred temperature units (Fahrenheit/Celsius).
• Access the AGS Energy settings.
• Check the battery condition of any installed remote control (RVMasterSwitch).
• Access a digital version of the RVMaster owner manual.
A detailed explanation of how all the systems and controls work through the touchscreen is
beyond the scope of this manual. Refer to the BMPro RVMaster manual in your warranty
packet for complete operating, setup and programming instructions.
A digital version of the operator manual may be included with the system. On the HOME
screen (upper right corner) press the SETTINGS button (the small Gear icon) then scroll the
screen down with your nger until you see USER MANUAL. Tap on it to open the manual.
To return to the beginning, tap the screen and a drop down appears at the top of the screen.
Select the back arrow at the top left to return to the menu screen. To get back to the display
HOME screen, press the left facing triangle button at the bottom of the screen.
Testing The Campsite Power Connection
Campsite 120-volt power receptacles can be tested using a digital multimeter or a dedicated
circuit analyzer. Dedicated circuit analyzers plug directly into the campsite power recep-
tacle and minimally test for open neutral, open ground, and correct polarity.
Always test the external power source (i.e., the campsite power receptacle or electrical box)
with a ground monitor before connecting your power cord to it. If the ground monitor indi-
cates ‘reverse polarity’ or an ‘open ground’ DO NOT connect the power cord.
To help prevent power surges from damaging the connected loads, please follow these in-
structions when hooking up to the external power source:
1. Turn o the load center main 120-volt circuit breaker.
2. Carefully extend the entire length of the power cord (approximately 25’-35’) from the
electric cable hatch to the external power source.
3. Plug the power cord into the receptacle. Be sure all the power cord prongs are properly
plugged into the receptacle.
4. Return to your RV and turn on the load center main circuit breaker.
To Next Page
Loading...
