80
1. The room is now free to move. Using either a 5/8” or 3/4” wrench or socket, crank
the room either in or out completely. If the slideout system is supplied with a gearbox
override (optional), use the crank handle to move the room.
2. When the rooms is fully in or out have one person apply pressure to the wrench/ratchet
and return the brake lever to its engaged position. This ensures the room is locked into
a sealed position.
1. Install the transit bars (if so equipped) to
the slideout room and take the unit to an
authorized dealer for service.
Refer to the Power Gear® Electric Slideout
Operation Manual for detailed operation, safety
and troubleshooting information.
The Power Gear® Slim Rack slideout is typi-
cally used for slideouts 144” long and longer.
It is operated by a 12VDC electric
motor.
The system is equipped with a manual override allow-
ing the room to be extended / retracted in the event of
a power loss.
The system has a controller (Fig 1) with programma-
ble stops that stop the motor when the room is fully
extended or retracted.
The controller has the ability to detect faults for easier
troubleshooting.
A wall mounted touchpad allows room movement and
provides end user feedback.
The slideout will not function until the stops are properly set
or faults are cleared.
indicates room movement.
with the sys-
tem. (Refer to the Fault Diagnostics / Troubleshooting).
To ensure ample voltage is being supplied to the slideout sys-
tem motor, power should be supplied from one of the following
sources:
Attach the RV to shore power.
Have the motorhome engine running.
Turn on the generator.
1. Engine or generator must be running, or plugged into shore
power.
2. Transmission must be in park or neutral (if applicable).
3. Set the parking brake and level the unit.
4. Remove transit bars (if so equipped) if extending the room;
install if retracting.
To Next Page
Loading...
