45
1. Open the entrance/screen door all the way.
2. Twist the locking handle to release the steps from the
locked position on the door frame ().
3. Lower the step assembly to the ground .
4. Adjust the feet to stabilize the steps ().
5. Remove pins (D) on each side of the step to adjust the
legs, then reinsert the pins to lock the legs.
6. Fold the handrail at the door out of the way or remove
the optional step handrail (if so equipped).
7. Pull pins from adjustable legs (D), and retract the legs
so they t inside the doorway when steps are folded.
Reinsert the pins to lock the legs.
8. Lift the steps and rotate up into the doorway.
9. Steps will automatically latch into brackets on each side
of the door frame as they are lifted in place.
10. Close the entrance/screen door
Entrance Door
Always hold onto the entrance door when opening or closing it. Damage caused because
you failed to do so is not covered by the
The entrance screen door may be equipped with a slide panel that allows access to the en-
trance door handle and locks. The entrance door may also be equipped with both a regular
door lock and a dead bolt lock.
Several keys are provided when you purchase your vehicle. Most keys have an individual
key number stamped on the plate. Record these key numbers and keep the information in a
safe place. You can order a key blank from your dealer to have duplicate keys made. If you
lose the keys, contact your dealer or a locksmith for assistance.
Make sure the entrance door is completely closed and locked when traveling.
Locking the door helps prevent it from opening unintentionally and keeps in-
truders from your recreation vehicle.
Certain models may have dual gas struts built into the step
mechanism make the steps very easy to raise and lower in place.
To Next Page
Loading...
