61
4. Push up on the bar latch handles that hold the ramp door in place, and move them to the
outside of the trailer to avoid contact when opening the ramp door.
5. Using caution, pull the ramp door open. Support the ramp door at all times and do not
let it drop to the ground.
As the trailer is being loaded, make sure that stored vehicle(s) and/or equipment do not dam-
age the ramp door seals. Remove any debris (sand, snow, etc.) from around the ramp door
before closing it. To close the ramp door, reverse the above process. Secure the ramp door
by locking the vice latches.
Inspect all ramp door components each trip for wear or damage. Contact your RV dealer for
a service appointment if repairs are needed.
Your RV may be equipped with an automated ramp door. Follow
all precautions and warnings listed previously for the manual ramp
door.
he automated ramp door is operated with a keyed switch located
on the outside of the RV (o door side) next to the shore power
plug. Insert the key in the key switch and turn it ON.
Press and hold the momentary switch down to lower the ramp
door. The switch must be held until the door is completely low-
ered. If you release the switch, the door will stop until the switch
is pressed and held again.
With the key ON, press and hold the momentary switch UP to raise
the ramp door. When the ramp door is closed, release the switch
and turn the key OFF.
For automated ramp doors (if so equipped), turn the keyed power
switch ON, the press and hold the momentary switch to lower the door.
Do not move the RV until the cargo ramp door is closed and
secured.
To Next Page
Loading...
