time e.g. 1/2 year to 1 year, the battery could be discharged so that the data stored in the memory is lost. In this event, the programming must
be done again. Also after this kind of interval, the receiver must be left switched on for a period to allow the battery time to charge.
Under normal conditions the battery will have a life of 10 years. The battery should be changed by a qualified serviceman.
FM-Stereo/Mono
The MPX indicator will light up when the receiver receives a program with a pilot tone from an FM stereo transmitter. If the stereo program
is affected by noise, you can press in the Mono button. Then the stereo program will be reproduced in mono with less noise. The MPX
indicator will continue to be on to indicate that the receiver is receiving a stereo program.
At low signal strength the receiver will automatically switch over from stereo to mono.
Servo (Automatic Frequency Control)
The Servo circuit ensures the automatic precision centre-tuning of a manually tuned station.
● Press the Servo button to bring in the Servo circuit. The light will come on.
● When you are tuning in a weak station which lies close to a strong station on the scale, it can be an advantage to disconnect the Servo
to prevent the Servo from automatically locking itself on to the stronger of the two stations.
During manual tuning the Servo will be disconnected as soon as you touch the Tuning knob. Re-connection of the Servo circuit is automatic
within 1 to 2 seconds after you release the knob.
Muting
The muting circuit blocks weak signals and thereby ensures noise-free manual tuning.
● Press the Muting button to bring in the muting circuit. The indicator light will come on.
● To tune in a weak station, first release the Muting button to cancel the effect of the muting circuit. Otherwise the weak stations will
not rise above the muting threshold.
Mounting the side panels (extra)
NOTE!
When fitting extra side panels you must use the long screws (A) which are supplied.
Take care of the short screws (B) originally used to hold the side panels because you will need them if you remove the extra side panels.
The long screws must not be used without the extra side panels because they will cause damage inside the receiver.
Mounting the 19" rack mount kit (extra)
See figure.
To Next Page
Loading...
Need help?
General
