THORLABS TXP5004 - Certifications and Compliances

© 2017 Thorlabs GmbH24
TXP5004
7.2 Certifications and Compliances
Category
Standards or description
EC Declaration of
Conformity - EMC
Meets intent of Directive 2004/108/EC
1
for Electromagnetic Compatibility. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the European
Communities:
EN 61326-1:2006
EMC requirements for Class A electrical equipment for measurement,
control and laboratory use, including Class A Radiated and Conducted
Emissions
2,3,4
and Immunity
2,3,5
.
IEC 61000-4-2
Electrostatic Discharge Immunity (Performance Criterion C)
IEC 61000-4-3
Radiated RF Electromagnetic Field Immunity
(Performance Criterion A)
IEC 61000-4-4
Electrical Fast Transient / Burst Immunity (Performance Criterion C)
IEC 61000-4-5
Power Line Surge Immunity (Performance Criterion C)
IEC 61000-4-6
Conducted RF Immunity (Performance Criterion A)
IEC 61000-4-11
Voltage Dips and Interruptions Immunity (Performance Criterion C)
EN 61000-3-2
AC Power Line Harmonic Emissions
EN 61000-3-3
Voltage Fluctuations and Flicker
Australia / New Zeeland
Declaration of
Conformity - EMC
Complies with the Radiocommunications Act and demonstrated per EMC Emission Standard
2,3,4
AS/NZS 2064
Industrial, Scientific and Medical Equipment: 1992
FCC EMC Compliance
Emissions comply with the Class A Limits of FCC Code of Federal Regulations 47, Part 15,
Subpart B
2,3,4
.
EC Declaration of
Conformity - Low
Voltage
Compliance was demonstrated to the following specification as listed in the Official Journal of the
European Communities:
Low Voltage Directive 2006/95/EC
6
EN 61010-1/A2:1995
Safety Requirements for Electrical Equipment for Measurement, Control
and Laboratory Use
U.S. Nationally
Recognized Testing
Laboratory Listing
UL3111-1
ANSI/ISA
S82.01:1994
Standard for Electrical Measuring and Test Equipment
Safety Standard for Electrical and Electronic Test, Measuring,
Controlling and Related Equipment
Canadian Certification
CAN/CSA C22.2 No.
61010-1 3
nd
ed.
Safety Requirements for Electrical Equipment for Measurement, Control
and Laboratory Use
Additional Compliance
IEC 61010-1:2010
Safety Requirements for Electrical Equipment for Measurement, Control
and Laboratory Use
Equipment Type
Test and Measuring
Safety Class
Class I equipment according to IEC 61010-1, Annex H, grounded product
1
Replaces 89/336/EEC.
2
Compliance demonstrated using high-quality shielded interface cables shorter than or equal to 3 meters.
3
Compliance demonstrated with various TX Series light source and electrical modules installed
4
Emissions, which exceed the levels required by these standards, may occur when this equipment is connected to a test object.
5
Minimum Immunity Test Requirement
6
Replaces Low Voltage Directive 73/23/EEC, amended by93/68/EEC