Thunder Laser NOVA-24 User Manual

THUNDER LASER
NOVA-24
www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel :(86)769 826653
Dongguan City, Guangdong Province, China
1
THUNDER LASER
SYSTEMS
User’s manual for NOVA-24
www.thunderlaser.com
tech@thunderlaser.com
December, 2019
Original Instruction

Thunder Laser NOVA-24 Specifications

General

Laser Type	CO2
Engraving Area	600mm x 400mm
Engraving Speed	0-1000 mm/s
Resolution	1000 DPI
Connectivity	USB
Drive System	Stepper Motor
Cooling System	Water Cooling
Min Line Width	0.01mm
Software	RDWorks / LightBurn
Operating Voltage	110V/220V AC, 50/60Hz
Positioning Accuracy	0.01mm
Repeat Positioning Accuracy	0.01mm
Power Supply	AC 110-220V ±10%, 50-60Hz
Operating Humidity	5% - 85%
Supported File Formats	AI, BMP, DST, DXF, PLT

Summary

Introduction and General Information

1.1 General Information

Essential initial reading for safe and correct operation of the laser system.

1.2 Designated Use

Defines the intended applications and materials for the NOVA-24 laser system.

1.4 Technical Data / Device Specification

Lists key mechanical, dimensional, and feature specifications for the NOVA-24 laser.

Safety and Installation Procedures

2.1 General Safety Information

Guidelines for all personnel involved in operation, maintenance, and repair of the machine.

2.3 Operating Safety Precautions

Essential safety measures to follow during device operation and handling, including fire and electrical hazards.

3.1 Unpacking and Location Setup

Steps for safely unpacking the machine and selecting an appropriate installation location.

3.8 System Connections

Instructions for correctly connecting power, computer, exhaust, air, and cooling systems.

Software Setup and Machine Operation

4.2 ON/OFF Switch

Details on the main and laser supply power switches for starting the machine safely.

4.3 Software Setup and Connection

Guides for installing RDWorks software and establishing PC communication with the machine.

4.4 Display and Control Panel Usage

Explanation of the control panel buttons, main interface, and parameter settings.

4.7 Focus Adjustment Methods

Procedures for manual and automatic focus distance adjustment for optimal cutting/engraving.

Advanced Operations and Maintenance

4.6 Laser Head Replacement

Instructions on how to replace the standard laser head with 4-inch or HR heads.

4.11 First Time Laser Operation

Step-by-step guide for performing initial engraving tests on the laser system.

5.1 Machine Cleaning

General guidelines and notes for cleaning the laser machine's interior and exterior components.

5.2 Optical Part Cleaning

Detailed procedures for cleaning the focus lens, mirrors, and beam combiner for clarity.

5.6 Maintenance Plan

Daily and weekly checklists for routine machine inspection, cleaning, and upkeep.