Contents
Chapter1 General Question ................................................................................................ 2
1.1 How to disassemble Nova ....................................................................................... 2
1.2 Operation manual for Thunder laser machine ......................................................... 4
1.3 System Maintenance .............................................................................................. 9
1.3.1 DAILY CHECK LIST ............................................................................................ 9
1.3.2 WEEKLY CHECK LIST ............................................................................................ 10
1.3.2 MONTHLY CHECK LIST ................................................................................... 11
1.4 How to judge if the laser power become weaker? ................................................ 15
Chapter2 Laser cutter machine ........................................................................................ 16
2.1 Alarm of LCD panel—Frame/X/Y Slop over............................................................ 16
2.2 Alarm of LCD panel—No enough extend space ..................................................... 17
2.3 Alarm of LCD panel—Water error ......................................................................... 19
2.4 Alarm of LCD panel—Machine protected .............................................................. 21
2.5 The machine won’t turn on................................................................................... 22
2.6 Y-axis not moving at all ......................................................................................... 24
2.7 X-axis not moving at all ......................................................................................... 26
2.8 The laser tube won’t fire the beam ....................................................................... 28
2.9 Why the red dot pointer not being able to come out from the laser head? ........... 30
2.10 Why the “Origin” button of LCD panel not working? ............................................. 32
2.11 Engraving problem—the engraving quality is very poor ........................................ 33
2.12 Cutting problem-- Some point of the same piece of materials cannot be cut through
35
2.13 Cutting problem– Why the starting point of a cutting graphic can’t meet with its
end point ........................................................................................................................ 37
2.14 Why noisy while moving laser head front and back, how to adjust? ...................... 41
2.15 Why does the machine beep continuously ............................................................... 44
Chapter3 Laser cutter software ........................................................................................ 48
3.1 How to prepare your files for feeding into the laser program to engrave .............. 48
To Next Page
Need help?
General
