Thunder Laser Nova - Weekly Check List

115 pages

Save Page as PDF

To Next Page

To Previous Page

www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD

tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian

Tel : (86)769 826653 Dongguan City, Guangdong Province, China

1.3.2 WEEKLY CHECK LIST

 Reflector

Use a lens cloth and lens cleaner to keep all mirrors clean

Main Page

Table of Contents1
Chapter1 General Question3
How to Disassemble Nova3
Operation Manual for Thunder Laser Machine5
System Maintenance10
Daily Check List10
Weekly Check List11
Monthly Check List12
How to Judge if the Laser Power Become Weaker16
Chapter2 Laser Cutter Machine17
Alarm of LCD Panel-Frame/X/Y Slop over17
Alarm of LCD Panel-No Enough Extend Space18
Alarm of LCD Panel-Water Error20
Alarm of LCD Panel-Machine Protected22
The Machine Won't Turn on23
Y-Axis Not Moving at All25
X-Axis Not Moving at All27
The Laser Tube Won't Fire the Beam29
Why the Red Dot Pointer Not Being Able to Come out from the Laser Head31
Why the "Origin" Button of LCD Panel Not Working33
Engraving Problem-The Engraving Quality Is very Poor34
Cutting Problem- Why the Starting Point of a Cutting Graphic Can't Meet with Its38
End Point38
Why Noisy While Moving Laser Head Front and Back, How to Adjust42
Why Does the Machine Beep Continuously45
Chapter3 Laser Cutter Software49
How to Prepare Your Files for Feeding into the Laser Program to Engrave49
How to Prepare Your Files for Feeding into the Laser Program to Cut55
Communication Error57
Ethernet Cable Connection57
USB Cable Connection60
How to Run Several Laser Machines with One PC Via Ethernet Cable62
How to Run Several Laser Machines with One PC Via USB Cable Connection64
How to Setup Wireless Network Connection for Thunder Laser Machine66
How to Run Several Laser Machines with One PC Via USB Cable69
How to Import PDF Files into Rdworks70
How to Install the Coreldraw Plugin for Rdworks71
Wrong Proportions from Rdworks73
Why Does the Graphic Size that Imported to Rdworks Different from Its Original Size75
Engraving Problem-How to Improve Engraving Quality in the Scan Mode of X-Swing76
Why Does the Cutting and Engraving Graphics Reverse (Mirror)80
Laser Cutter Has a Wrong Cutting/Engraving Size81
Laser Cutter's LCD Panel in Chinese85
Chapter4 Component Maintenance86
How Do I Replace the Controller Board86
How to Replace Laser Tube90
Disassembly Procedure90
How to Adjust and Replace the Motor92
How to Calibrate the Working Table to Level94
How to Replace the Rollers and Adjust the X Axis Shaft96
How to Adjust the Verticality between the X and y Axis99
How Do I Replace the Drive Shaft Module102
External Accessory Problem106
Exhaust Fan Cannot Extract Smoke or Dust106
Air Pump Won't Work or no Air Assist When Job Starts107
Chiller Alarms Unusually109
Rotary Axis Attachment Has a Wrong Cylindrical Engraving/Cutting Size111

Thunder Laser Nova - Weekly Check List

Table of Contents

Related product manuals