www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel : (86)769 826653 Dongguan City, Guangdong Province, China
Chapter2 Laser cutter machine
2.1 Alarm of LCD panel—Frame/X/Y Slop over
LCD panel shows the following information:
Here are the reasons:
The size of the graphic is larger than the working area of the machine
If your laser cutter’s working area is 600×400mm, but you want to cut a graphic which larger
than 600×400mm, this warn appears. Since the laser is not able to work beyond its working.
Incorrect starting point
If you set an incorrect starting point, the graphic might be out of bounds. Please set a correct
starting point to resolve this problem, like below.
End
To Next Page
Loading...
