Thunder Laser Nova - Why the Red Dot Pointer Not Being Able to Come out from the Laser Head

www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel : (86)769 826653 Dongguan City, Guangdong Province, China
30
2.9 Why the red dot pointer not being able to come out from
the laser head?
Here are the reasons:
 The red dot pointer is off
Locate on the Red Dot Pointer Mount in the rear of the machine, and check if the Red Dot Pointer
is off, like below.
If yes, please open the lower left hand door panel, find the connector for the red dot and check if
it’s connected well, like below.
 The red dot pointer is not aligned
Procedure: Align the Red Dot pointer
1. Move the laser head on the middle of the working table.
2. Place a square of masking tape over the left side of the third mirror carriage, and mark a dot
on the center, like below.