www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel : (86)769 826653 Dongguan City, Guangdong Province, China
2.13 Cutting problem– Why the starting point of a cutting
graphic can’t meet with its end point
This problem is due to the different movement of the belt on both sides of the Y-axis, which
lead the belt is not synchronized.
Here are the reasons:
The coupling loose;
Please check if one of couplings is loose like below:
If yes, please tighten it in clockwise with M5 Allen wrench.
The gear of transmission shaft loose
Please check which side of gear of transmission shaft is unfixed like below:
To Next Page
Loading...
