www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel : (86)769 826653 Dongguan City, Guangdong Province, China
2.7 X-axis not moving at all
Here are the reasons:
X-axis limit switch problem
Locate on the left side of x-axis, please check if the wiring and roller lever of switch are well or
not, like below.
If they both seem to be well, please test is x-axis limit switch working properly according to the
video below.
https://www.youtube.com/watch?v=yQZQWIWIotU
The interface of x-axis motor have bad connection
If the x-axis limit switch is working properly, please open upper right hand door panel, check if
the interfaces of x-axis motor are connected well, like below.
Please power off the machine, re-connect the interface then try again.
Motor or driver of x-axis is broken
Please open lower right hand door panel, check the x-axis driver (red LED should be up and
flashing), like below:
To Next Page
Loading...
