www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel : (86)769 826653 Dongguan City, Guangdong Province, China
3.13 Why does the cutting and engraving graphics reverse
(mirror)?
This problem may cause from improper setting of the software.
Please start up the laser software RDWorksV8. And then click “Config” – “system setting” on the
menu bar. This dialog box appears.
Make sure “Axis X mirror” is unticked, and “Axis Y Mirror” is must ticked.
If your setting is different from this, this is the problem why your cutting/engraving reverse. Just
reset the config as above.
End
To Next Page
Loading...
