www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel : (86)769 826653 Dongguan City, Guangdong Province, China
3.14 Laser cutter has a wrong cutting/engraving size
If this problem occurs, generally the pulse setting of the X/Y axis motors is wrong.
Please follow the below steps to solve the problem
Please draw a 100x100mm square using the cut mode and send to your laser cutter and cut the
square.
Let’s say the actual size of the square measured is 98x95mm
To Next Page
Loading...
