Thunder Laser Nova - How to Run Several Laser Machines with One PC Via Ethernet Cable

www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel : (86)769 826653 Dongguan City, Guangdong Province, China
61
3.4 How to run several laser machines with one PC via
Ethernet cable
If there is an Ethernet hub in your network, it’s able for one PC (laser software) to connect with
several machines.
But pc will does only communicate with one machine and sending the file into the laser in the
same time.
1. Ethernet hub setup;
PC to hub, one port of the hub goes to a laser machine.
2. Configure laser cutter machine;
Go to LCD Panel>>Z/U Button>>IP config+.
Default machine IP: 192.168.1.100, like below.
For other machine, you may have other IP address as 192.168.1.X.
3. Configure laser cutter software;
Add the Web port for each machine according to their IP address, like below.