Thunder Laser Nova - Air Pump Wont Work or no Air Assist When Job Starts

www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel : (86)769 826653 Dongguan City, Guangdong Province, China
106
4.8.2 Air pump won’t work or no air assist when job starts
Here are the reasons:
 Air compressor break down;
How to check if air compressor break down, there’s a common way to connect it to the power
directly using the power cable of chiller, then check if air compressor can be turn on normally.
See below.
 Wrong setting
The air assist can be controlled by the layer parameter of software, please make sure you have “If
Blowing” selected to YES, like below
Note: If the Processing Mode is Cut, “If Blowing: Yes” must not be changed.
 The air valve is close
Make sure have the manual air valve opened（horizontal means open）, like below.