Thunder Laser NOVA-24 - Advanced Operations and Maintenance; 4.6 Laser Head Replacement

THUNDER LASER
NOVA-24
www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel :(86)769 826653
Dongguan City, Guangdong Province, China
51
4.6 How to replace the 4 inch and HR laser head
Both 4 inch laser head and HR laser head are option item.
The 4 inch laser head is suitable for cutting materials with a thickness> 10mm.
With this look, you can achieve vertical cuts in 20 or 30mm thick materials, such as PU foam,
acrylic or wood.
The High Resolution head can focus the laser beam much finer than the standard laser head.
This allows very delicate engraving or extremely precise cuts in films, cardboard or paper.
For cutting materials thicker than 1mm, the HR head is not suitable.
1
）
How to replace the 4 inch laser head
1. Move the table down till there’s enough space to take the standard head out and install
the 4” laser head.
2. Remove the standard head like below：
① Take out the air hose
② Loosen the screw
3. Install the 4” laser head like below:
① Fix the laser head
② Connect the air hose
Please always insert the 4’’ laser head as far as it will go.