www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel :(86)769 826653
Dongguan City, Guangdong Province, China
3.8 Connections
Perform the connections exactly in the order described; otherwise
electrostatic charging can damage your computer and/or the electronics
of the laser system.
3.8.1 Connecting the Mains
Connect one end of the mains cable with the connection socket at the rear side of the
laser device (see Figure below) and the other end with a protected power outlet.
Mains voltage and operating voltage must correspond (AC 230V 50/60 Hz or AC 115V
50/60 Hz) – see information label beside the connection socket.
Under no circumstances switch on the device if the voltages do not
correspond.
To Next Page
Loading...
