www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel :(86)769 826653
Dongguan City, Guangdong Province, China
MaxPower1：
%
Modified press Enter
30.0
MaxPower2：
Press Z/U move item
%
30.0
Layer0：
MinPower1：
%
22.0
MinPower2：
%
30.0
Speed
：
mm/s
400
4.4.6 Z/U button
The Z/U button can be pressed when the system is idle or the work is finished. On
pressing this button, it will show some entries in the following interface:
Z Move: When the green block is on “Z Move” item, to move the Z-axis table up
and down by pressing left and right arrow button.
U Move: When the green block is on “U Move” item, to control the rotary
attachment to turn by pressing left and right arrow button.
Axis Reset+: When the green block is on this item, you can manually reset the
axis if needed.
Set default para: To recover all manufacturer parameters and user parameters
for your machine
Auto Focus: To use the auto focus function.
Language: The item “Language” helps you to select a appropriate langue which
is displayed on the panel:
IP Setup: The machine is already assigned an IP address as 192.168.1.100,and
the IP address on software should be the same while communicate
To Next Page
Loading...
