Thunder Laser NOVA- 35 - System Connections; Connecting the Mains Power

THUNDER LASER NOVA-
35
www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT
CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel :(86)769 826653 Dongguan City, Guangdong Province,
China
23
3.8 Connections
Perform the connections exactly in the order described; otherwise
electrostatic charging can damage your computer and/or the
electronics of the laser system.
3.8.1 Connecting the Mains
Connect one end of the mains cable with the connection socket at the rear side of the laser
device (see Figure below) and the other end with a protected power outlet.
Mains voltage and operating voltage must correspond (AC 230V 50/60 Hz or AC 115V
50/60 Hz) – see information label beside the connection socket.
Under no circumstances switch on the device if the voltages do not
correspond.