Thunder Laser NOVA- 35 - Air Assist Control Settings

THUNDER LASER NOVA-
35
www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT
CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel :(86)769 826653 Dongguan City, Guangdong Province,
China
58
“up” button you can change the value, then click “Set” button to confirm and go into the
next interface. On the OUT8 interface, click again the “Set” button, the display will be off
and exit the delay time setup.
4.9 How to use air-assist control
The Air-assist control is an additional tool for laser machines.
Generally, cutting needs the air assist with high air-volume but engraving needs the air
assist with low air-volume.
Air-assist control is available in high- and low-volume for engraving and cutting-jobs via
software-setting, this will increase the ease of use of your laser machine.
1） How to select the air assist with high volume or low volume?
In RDwork software, high volume or low avolume is selected on the “Air-Assist Control”
option. We suggest select “High” for cut mode and select “Low” for scan mode(engraving
mode).