THUNDER LASER NOVA-
35
www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT
CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel :(86)769 826653 Dongguan City, Guangdong Province,
China
2) How to adjust air volume if require?
For High volume mode,
1. Make sure machine is not at work and laser switch is off
2. Click the left green button to start the air-assist with high volume
3. Check the air volume under the laser head
4. On left flow control valve, loose the locked nut then rotate the adjusting screw to control
the air volume to mean your requirements.
5. Fix the locked nut after finished.
And for Low volume mode, you do it the same.
It will be the best if using big air compressor instead of air pump for
air-assist.
4.10 How the heat alarm system works
The heat alarm system is an additional tool for laser machines.
Some materials such as acrylic, wood and so on, can easily catch fire, particularly during
cutting, the heat alarm system have a temperature sensor board which will react the
abnormal temperature(higher than 55°C/131°F) on material processing chamber. It will
trigger at a certain temperature to stop laser processing and give a warning sound, so
operator can active fire control in time to reduce the potential losses and risks.
To Next Page
Loading...
