THUNDER LASER NOVA-
35
www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT
CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel :(86)769 826653 Dongguan City, Guangdong Province,
China
4.5 How to use the different nozzles laser head cone
The standard laser head is equipped with a 2 "(50.8mm) focusing lens and focuses the laser beam
to a diameter of about 0.14mm (when using a glass laser tube).
With this laser head, you can perform fine engraving work (such as letters with 1.5mm height) and
cut materials up to 10mm thickness with good quality (depending on the laser power of the
machine).
The standard laser head is supplied with 2 air nozzles laser head cone.
A nozzle has a very narrow outlet (approx. 2mm), which provides high air flow to blow directly on
the cutting gap. This nozzle is excellently suited for cutting wood, as this prevents soot formation
in the cutting gap.
The other nozzle has a large outlet (approx. 6 mm), which provides the air assist to blow the
material more slowly and not directly on the cutting gap. This nozzle is excellently suited for cutting
acrylic, as this prevents white mark in the cutting edge. Besides, when engraving wood, for example,
particles that have been removed and smoke / gases are gently distributed and extracted in the
working area. So you get a clean, almost unaffected by smoke traces engraving.
The 6mm nozzle laser head cone are placed inside the toolbox.
To Next Page
Loading...
