16
CCAANNOOPPYY IINNSSTTAALLLLAATTIIOONN
❐ 50.Trim the canopy along the molded line. Secure
the canopy in place with furnished six
3x8mm wood screws.
3x8mm
❐ 51.Install the throttle servo. Secure the EZ
connector with two M2 washers and nut on
the servo horn and adjust the throttle with
radio on then secure the throttle pushrod with
3x3mm set screw.
M2
❐ 52.Install the switch and connect to receiver.
Wrap the receiver and battery pack in foam
padding. Route the RX antenna and drill a
small hole on right side of fuselage. thread the
antenna out of fuselage then tape it along the
fuselage to tail.
Control Throws
These control throws are merely a starting point
for your radio setup and can be tailored to fit your
flying style.
Center of Gravity
IMPORTANT- Do not attempt to fly your model
before completing this very important section. A
model that is not properly balanced will be unstable
and could cause serious damage and/or injury.
Adjust the battery location or add weight as needed
to achieve level balance. Once you have everything
positioned as necessary, wrap your battery pack in
1/4" or 1/2" thick foam for protection.
The balance point is about 5.5” (14mm)
from the leading edge.
14
To Next Page
Loading...
