❐ 44.Drill holes for needle valve, muffler bolt,
mixture screw and Precision Fuel Value
(TTR1115) for easy fueling. A reamer is
recommended ( TTR1120) to drill holes.
No. 1120
No. 1115
❐ 45.Insert the pushrod guide tube through the
fuselage and glue it in place. Install the
throttle pushrod. You might need to remove
the throttle lever first then attach to Z-bend
throttle pushrod end.
3
❐ 46. Now connect all fuel lines properly, stick the
decals before securing the cowl. Install
spainner and propeller.
15
CCOOWWLL AATTTTAACCHHMMEENNTT
❐ 47. When satisfied, secure the cowl with four
3x8mm wood screw.
3x8mm
❐ 48.Locate the landing gear slot at bottom of
fuselage. Cut away the covering and remove
the landing gear retainer.
❐ 49. Install the landing gear in place and glue the
retainer with thick CA. Install the wheel and
secure by collar with 3x3mm set screw.
AB 3x3mm
To Next Page
Loading...
