❐ 12. Secure control horn with furnished 2x14mm
screws and control horn backplate.
?
?
?
?
?
?
?
?
)Xf?/X?hg?
@)f?V/Xhg?
@HgN1hg?
@?e?@K??@fO)X?g?
@?e?@@@@@@@@@@@,?g?
@W@KC(M?gW(Y?g?
@@@@@@@@@He)Xe?W.Yh?
@??I@??J@)e?.Y?h?
@?fO&Y?hg?
@W.?@@@@@@@@@@@@@?g?
@(Y?e@?f@?he?
?@@@@Hf@?f@?he?
?@M?@?e?J5?e?J5?he?
@?e?7U?e?7H?he?
@?eJ@)KeJ5hf?
@?e.MI46T&Uhf?
@?gS@@)K?he?
@?f?O.M?I46X?h?
@?e?W2(Y?e?I/Xh?
?@@@5?eO&0YgV/h?
I(Y?@@0M ?
?
?
?
?
?
?
?
?
?
Z
❐ 13. Trail fit main wing in place then place
fuselage bottom section and make marks on
the bottom wing.
❐ 14. Draw a parallel line offset about 5/32"(4mm).
Locate 4 pieces of bottom section mount and
place the mounts right on the lines as shown.
9
WWIINNGG AASSSSEEMMBBLLYY
Locate the wing mounting plate and place it
at the center and away from trailing edge
about 1/8"(3mm). Make marks around these
wood parts.
4mm
3mm
❐ 15. Remove the covering of the marks you made.
❐ 16. Glue the wood parts in place with thick CA or
epoxy. Note that wing mounting plate is
1/8”(3mm) away from trailing edge.
AB
To Next Page
Loading...
Need help?
General
