What to do if Tide TEVS10-K07 Battery Charger is not turning on?
If your Tide Battery Charger isn't turning on despite receiving power, make sure the system power is on by checking the circuit breaker switch inside the charger. Also, verify that the circuit breaker in the distribution panel is turned on inside the charger.
Why does Tide TEVS10-K07 stop shortly after starting?
If your Tide Battery Charger stops charging shortly after starting, it could be due to a fully charged EV battery, which will cause charging to end automatically. Alternatively, there might be an issue with the EV itself. Please check the EV status, and if problems persist, contact the manufacturer.
What to do if Tide TEVS10-K07 Battery Charger charging cannot proceed?
If your Tide Battery Charger doesn't allow charging to proceed, ensure that you've connected the charging connector to the EV and tagged the product body with an NFC to start charging. If there are error messages or an Error LED is on, refer to the section on "Error Code of Charger."
Why user authentication cannot be identified on Tide Battery Charger?
If user authentication fails on your Tide Battery Charger, ensure that you are using a registered, authorized card. Also, to stop charging, you must use the same card that was used to start the charging session for authentication.
What to do if Tide TEVS10-K07 Battery Charger stops repeatedly during charging?
If your Tide Battery Charger repeatedly stops during charging, check the condition of the EV. For further assistance or if the cause is difficult to determine, contact the A/S center or the manufacturer for service.
General| Brand | Tide |
|---|---|
| Model | TEVS10-K07 |
| Category | Battery Charger |
| Language | English |
To Next Page