9
8
Precautions
Precautions
Precautions when installing EV Charger
Safety Precautions for Use
Precautions Prior to EV Charger Installation
Important information before installation and use
The following is to prevent user safety and property damage in advance,
so please read it carefully and follow it.
·
During trial operation, you must perform trial operation according to the basic
operation sequence.
·
Use it according to the instructions displayed on the screen, and in case of an
abnormality, stop using it immediately and contact the service center.
·
Excessive manipulation of the charger and improper use of the charger may
cause damage to the product.
·
It is prohibited to arbitrarily change the location of the charger from the place
where it was originally installed.
·
Relocation of the charger location can be requested through A/S.
·
Please use a dry towel when cleaning to keep the charger clean.
(Never spray water or use a wet towel. There is a risk of electric shock and
damage to internal components.)
·
If there is moisture inside the charging connector, be sure to remove the
moisture before use.
·
Be careful not to let foreign substances enter the charger in case of a risk
for fire.
·
When not using the charger, be sure to store the charging cable and charging
connector as described in the manual.
·
When opening the front panel of the EV charger or the back cover of the
stand, be sure to use the key provided.
·
When installing the charger, the lowest point of the charging connector must
be installed within 0.5~1.5M from the ground.
Expertise Requirements for Product Installation
The installation work and initial operation check of the charger should be
carried out only by engineers who have completed installation training from
the manufacturer
·When installing the product, the engineer must have the necessary safety
equipment, including insulated gloves, a safety helmet, safety goggles or face
shield, safety clothing, and any required tools.
·Required that the installer has received education and training in first aid in case
of an emergency.
·Please note that physical damage caused by unqualified installers will be
charged, even if it occurs within the warranty or A/S period.
Precautions when opening the door of EV charger for maintenance
·Be sure to turn off the circuit breaker of the distribution panel before opening
the EV charger.
·Be careful with handling the internal circuits and parts.
(There is a risk of electric shock due to the circuit where AC 230V voltage flows.)
·Please, open after contacting the service center.
·Be sure to close the EV charger tightly after opening and closing it.
·Please read this manual carefully and check the product before installing,
operating or maintaining the charger.
·After reading the manual, keep it in a place where the user can see it at any time.
·In order to use the product's functions safely, fully familiarize yourself with
the manual in advance.
·When using the EV charger, there is a risk of electric shock or explosion due to
the high voltage and current.
·However, in normal operation, it is designed to be sufficiently safe so that there is
no danger to the user.
·This charger may have different internal systems depending on the country of
installation. Be sure to check the country and environment when installing.
·If this manual is damaged or lost, you can download it from our homepage.
To Next Page
Loading...