13
Opening A Vault (Courier)
Step 1: The Courier must insert the DataKey into the DataKey
Reader and turn it (the DataKey can then be removed).
NOTE: If the Courier has access to both vaults, a prompt for vault
selection will appear. Select the desired vault.
NOTE: If the Door Policy requires a Manager or Employee to assist
with door opening, the prompt “Please ask a Manager/Em-
ployee to assist in opening the vault”. Select “Done” and enter
the appropriate code.
Step 2: The Vault solenoid will activate and the handle on the vault
door can be turned.
Closing A Vault (Courier)
When the vault is closed and locked, several prompts may appear,
depending on Policy settings:
!!
!!
! “I think the Courier was just here. Should I clear the Bill
Acceptor totals?”
Selecting “YES” will set the number of bills in the Bill
Acceptor to 0.
!!
!!
! “I think the Courier was just here. Did they leave anything
in the vault?”
This appears when the Main Vault was opened by the
Courier.
Selecting “YES” will prompt the user to enter the amount
left by the Courier.
!!
!!
! “Press done when you have removed the 1st receipt”
This appears when receipts are required after door clos-
ings.
To Next Page
Loading...
