1600 mm (815 mm with funnel removed)
1565mm
(815mm with
funnel removed)
800mm
Designed to chip solid wood material up to 75mm in diameter and capable of
chipping over 0.75 tonnes of brushwood per hour.
PURPOSE
Engine type:
Honda 4 stroke OHV
Maximum power:
9.6kW (13hp)
Cooling method:
Air cooled
Overall weight:
188kg
Starting method:
Recoil
Type of feed:
Gravity
Maximum diameter material:
75 mm (3”)
Fuel capacity:
6.5 litres
Material processing capacity:
Up to 0.75 tonnes/hr
Fuel type:
Unleaded petrol
DIMENSIONS
TW 13/75G
2 / 32
INTRODUCTION
C190-0187 25.01.2019 Rev: 1.0
Thank you for choosing Timberwolf. Timberwolf chippers are designed to give safe
and dependable service if operated according to the instructions.
IMPORTANT HEALTH AND SAFETY INFORMATION
Before using your new chipper, please take time to read this manual. Failure to do
so could result in:
- personal injury
- equipment damage
- damage to property
- 3rd party injuries
This manual covers the operation and maintenance of the Timberwolf TW 13/75G.
All information in this manual is based on the latest product information available at
the time of purchase.
All the information you need to operate the machine safely and effectively is
contained within pages 3 to 11. Ensure that all operators are properly trained for
operating this machine, especially in safe working practices.
Timberwolf's policy of regularly reviewing and improving their products may involve
major or minor changes to the chippers or their accessories. Timberwolf reserves
the right to make changes at any time without notice and without incurring any
obligation.
Due to improvements in design and performance during production there may be,
in some cases, minor discrepancies between the actual chipper and the text in this
manual.
The manual should be considered an important part of the machine and should
remain with it if the machine is resold.
CAUTION or WARNING
BE AWARE OF THIS SYMBOL
AND WHERE SHOWN,
CAREFULLY FOLLOW THE
INSTRUCTIONS.
THIS SYMBOL INDICATES
IMPORTANT SAFETY
MESSAGES IN THIS MANUAL.
WHEN YOU SEE THIS
SYMBOL, BE ALERT TO THE
POSSIBILITY OF INJURY TO
YOURSELF OR OTHERS AND
CAREFULLY READ THE
MESSAGE THAT FOLLOWS.
ALWAYS FOLLOW SAFE
OPERATING AND
MAINTENANCE PRACTICES
TW 13/75G SPECIFICATION
Serial No. Location.
The serial number
can be found on
the identification
plate located on
the rotor housing.
To Next Page
Loading...
