Operating Instructions
Operate the controls only while standing in the OPERATOR ZONE shown in the sketch below. Never operate the log splitter
from any other location.
• Read engine manual for starting and maintenance instructions
• Let engine run for at least ten (10) minutes (or longer in cold weather) to allow the hydraulic oil to warm up to at least 80°
on temperature guage
Note
Read engine manual fi rst. Always run the engine between ¾ throttle and full throttle.
• Handle logs from the sides only, never from the ends
• Place log with butt (wider) end toward the push block
• Position log on the cradle’s centerline
• Steady log by placing your left hand on top of it, midway
between its two ends
• Steady log only until it is fi rmly held between the push
block and the wedge
• Then move your hand away and keep your hands, arms and body away
from the wedge, log and push block until the push block is completely retracted
• Use a stick to remove debris from the splitting area. Never use your hands or feet
Starting and Using the Log Splitter
Operating Instructions
19
TIMBERWOLF FIREWOOD PROCESSING EQUIPMENT
To Next Page
Loading...
